Learning-Based Behavior Planning for Automated Driving: Real-World Integration and Deployment

Recent research in machine and deep learning has shown the potential of learningbased motion planning approaches to improve the driving behavior of automated vehicles, especially in complex environments. However, their complex nature and lack of transparency can hinder explainability and trustworthiness and complicate safety assurance. Motivated by these challenges, we propose a hybrid planning architecture that combines the advantages of machine learning with the verifiability and the determinism of classical approaches. Specifically, we developed a deep neural network to interpret complex traffic scenes and propose driving behavior, while an optimization-based supervision layer validates this proposal and enforces explicit drivability and safety constraints. We evaluate the learned planner's driving behavior in open-loop studies on real-world urban data, discuss system integration aspects for stable closed-loop operation, and report results from real-world deployment on our research vehicle karl..

Robostreet Flow: A Lightweight, Ultra-Low-Drag Electric Tractor and Four-Truck Hybrid Convoy Architecture for Minimum-Cost Point-to-Point Freight

Line-haul trucking costs are dominated by three comparably sized components: energy, driver labor, and equipment. Most efficiency technologies address only one component at a time. This paper presents Robostreet Flow, a freight architecture that jointly optimizes the vehicle, convoy formation, and operating model to minimize cost per ton-mile on high-volume point-to-point corridors. The Flow platform is a battery-electric 6x4 tractor with a teardrop single-seat cab and a drag coefficient of 0.35, approximately 40% below that of conventional Class 8 tractors. A carbon-composite monocoque and structurally integrated batteries reduce net vehicle weight by 50%. A 513 kWh tractor battery and a 340 kWh powered trailer battery provide a 500-mile single-charge range. Four Flow trucks operate as a coordinated convoy with a safety driver only in the lead vehicle, while three followers operate in SAE Level 4 automated mode. Computational fluid dynamics simulations show that close following at an 8 m gap reduces follower drag coefficients by 42-48% and follower peak frontal pressure by approximately a factor of four relative to the exposed lead vehicle. A longitudinal energy model calibrated to these results predicts fleet-average consumption of 1.27 kWh/mi in convoy, compared with 1.60 kWh/mi for an isolated vehicle, for a 20.5% energy saving. Electricity cost is approximately 17% of the equivalent diesel fuel cost. Amortizing one driver across four trucks and accounting for the additional payload enabled by lightweighting reduce operating cost from 9.4 to 4.1 cents per ton-mile, a 56% reduction relative to a diesel baseline. Sensitivity analysis, a hub-to-hub operating concept, and regulatory implications are also presented.

Image Quality Dependent Degradation for AI Systems

Perception is one of the primary applications where neural networks outperform conventional algorithms. One example is AI systems for automated driving, which can detect pedestrians based on image data and avoid them accordingly. A substantial challenge with these AI systems is that their output depends heavily on the quality of the input images. For example, if an image is of inferior quality due to heavy contamination, such as noise or darkness, accurate predictions are hardly feasible. Additionally, various types of errors can occur, each with varying relevance to the trustworthiness of the underlying AI system. In particular, it may be more critical not to detect an existing person than to detect a person where there is none. Therefore, we want to show that we can still avoid the most critical errors in situations of inferior image quality. To achieve this, we aim to establish a fail-degraded system by lowering the network's confidence threshold based on the estimated image quality, enabling it to detect objects more cautiously in uncertain situations. Additionally, we present a novel method for estimating the quality of incoming images by comparing them to the training data using normalizing flows. We will also conduct experiments applying our method to state-of-the-art object detection. In summary, we will present a design strategy for AI-based systems in automated driving that can deal with poor-quality input data without resorting to fallback solutions. Such measures enhance trust in AI-based systems and lead to an increased provision of the AI component.

Sensitivity Analysis of GRU, LSTM and Transformer Encoder in Classification of Automated Driving Systems

Automated driving systems (ADSs) are becoming ubiquitous. Future Software Defined Vehicles (SDVs) may be able to run multiple ADSs, both native and aftermarket such as Comma.ai's Openpilot. Monitoring systems to independently verify which automated driving system is active are important for safety monitoring, regulatory compliance, insurance assessment, and anomaly detection. In this paper, we first evaluate the effectiveness of three sequence-based classification models: Gated Recurrent Units (GRU), Long Short-Term Memory (LSTM) networks, and a Transformer encoder model for identifying Level 2 automated driving systems using vehicle telematics data alone: Comma Openpilot, Tesla Autopilot, and Cadillac Super Cruise, along with manual driving. All three models achieve strong clean-data performance with macro F1-scores of 0.92 (GRU), 0.90 (LSTM), and 0.93 (Transformer encoder model) when trained on clean data; threat-matched training yields 0.904-0.916 macro F1 with only a modest clean-data penalty. Second, we introduce a modular robustness evaluation framework that simulates realistic telematics degradation through five corruption families at five severity levels (L1-L5). Continuous channels are perturbed using additive white Gaussian noise with cumulative drift, correlated cross-channel noise, and temporal jitter. Binary event signals are subjected to burst loss, delayed transitions, spurious toggles and cross-feature inconsistencies inspired by communication errors. Robustness is measured using macro-F1, which gives equal weight to each class and is suitable for imbalanced multiclass evaluation. Our evaluation reveals a sharp failure-mode split: event-level corruptions reduce macro-F1 only slightly (greater than equal to 0.87 at L5), while temporal jitter collapses macro-F1 to 0.44-0.50 across GRU, LSTM, and Transformer encoder model.

ROSA-RL: Uncertainty-Aware Roundabout Optimized Speed Advisory with Reinforcement Learning

Roundabouts challenge automated driving in mixed traffic, as heterogeneous and non-deterministic human behavior, unknown driving intentions, and high interaction complexity create uncertainty about whether the conflict zone will be blocked or available at the moment of entry. We present ROSA-RL -- uncertainty-aware Roundabout Optimized Speed Advisory with Reinforcement Learning. It enables safe and efficient roundabout entry for automated and human-driven vehicles in mixed traffic through probabilistic conflict forecasting. A Transformer-based model predicts conflict zone occupancy over a five-second horizon, capturing multi-agent interactions to anticipate upcoming conflicts and available gaps. The prediction outputs encode uncertainty in future motion and intent, and augment the state of a classical RL framework, enabling uncertainty-aware speed coordination. Evaluated in simulations grounded in real-world data, ROSA-RL can effectively handle uncertainty and outperform a comparable model-based baseline, closing the gap to an ideal setting assuming fully known occupancy while improving traffic efficiency and safety. The source code of this work is available under: github.com/urbanAIthi/ROSA-RL.

From Correlation to Causation in Lane Change Prediction for Automated Driving: A Causal Explanation Framework

Lane-change prediction is a central task in intelligent vehicles, where early maneuver anticipation can support safer decision-making. However, many existing approaches mainly learn statistical associations between observed driving variables and future maneuvers, while overlooking the causal dependencies among the input variables themselves. This limits interpretability, especially when physically related variables such as longitudinal gap, relative longitudinal velocity, and Time-To-Collision (TTC) are treated as independent flat inputs. This article presents a causal-inference-based framework for lane-change prediction and explanation. The proposed approach combines linguistic feature construction, expert-constrained causal discovery, deep structural causal modeling with Deep End-to-end Causal Inference (DECI), intervention-based effect analysis, refutation testing, and recursive causal-chain explanation. The objective is not only to predict the future maneuver, but also to identify candidate variables that directly contribute to the prediction, the upstream factors influencing them, and the causal chains through which these effects propagate. The framework achieves average F1-scores above 95% during the first three seconds before the lane-marking crossing event. Beyond prediction accuracy, the framework uses intervention-based effect analysis to distinguish influential from weakly influential variables under the learned causal structure. It further distinguishes candidate direct contributors from mediated effects and generates contrastive causal-chain explanations that clarify why the predicted maneuver is favored and why the alternative maneuvers are less supported. The main contribution is therefore a mechanism-aware lane-change prediction pipeline that moves beyond correlation-based classification toward more interpretable causal reasoning for maneuver prediction.